Цитата Сообщение от fgfgfg Посмотреть сообщение
Нет там ничего подобного
Таки нашел в чем дело, в описании прошивки написано:
"All 8 FWs have the new PTL function, which allows you to adjust max volume limit with 3dbfs steps. PTL means Push The Limit, this function uses combinations of UAC2 HW volume commands. To drop the limit for -30dbfs you should set the volume slider at min position next lift it up(not higher than 1/2 of the slider) and drop to the min volume again. If you repeat that voodoo 3 times during 2 seconds, the max volume limit will be set to -30dbfs. To increase the limit set the volume slider to the max position, next pull it down(not lower than 1/2 of the slider), and back again to the max position. After you repeat that at least 3 times, the limit will be increased for 3dbfs(you'll able to hear that), 6 times for 6dbfs, and so on up to 0dfbfs i.e. no limit at all. This way you can limit 9038SG3 power in the range from -30..0dbfs, and avoid loud shock with sensitive EIMs."
Т.е. появилась новая функция ограничения максимальной громкости с шагом 3 dbfs, от 0 до -30 dbfs. Чтобы уменьшить макс.громкость надо: убрать громкость до минимума, приподнять (меньше половины шкалы) и так 3 раза в течении 2 секунд. Это уменьшит макс.громкость на 3dbfs. Для увеличения - аналогично, только выставить максимум.
А то я голову ломал: как так - приложения под Андрюшу нет, под винду тоже не нашел софт для управления сабжем, а громкость меньше. Ладно хоть хватало для Тинок с запасом. Кстати, расход акка в таком режиме существенно меньше: на g2 акка Hiby R3 (транспорт) хватало часа на 4,5; с g3 примерно часов на 6.